Maximum solid solubility of transition metals in vanadium solvent

来源 :中国有色金属学会会刊(英文版) | 被引量 : 0次 | 上传用户:cnzhchch
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Maximum solid solubility (Cmax) of different transition metals in metal solvent can be described by a semi-empirical equation using function Zf that contains electronegativity difference, atomic diameter and electron concentration. The relation between Cmax and these parameters of transition metals in vanadium solvent was studied.It is shown that the relation of Cmax and function Zf can be expressed as ln Cmax = Zf = 7. 316 5-2. 780 5 (△X)2 -71. 278δ2 -0. 855 56n2/3. The factor of atomic size parameter has the largest effect on the Cmax of the V binary alloy;followed by the factor of electronegativity difference; the electrons concentration has the smallest effect among the three bond parameters. Function Zf is used for predicting the unknown Cmax of the transition metals in vanadium solvent. The results are compared with Darken-Gurry theorem, which can be deduced by the obtained function Zf in this work.
其他文献
The VCp reinforced stainless steel composite was produced by in-situ reaction casting. The composite was tested for its wear resistance under the wet abrasive c
Maximum bubble pressure measurement was employed to evaluate surface tension of Sn-8Zn-3Bi(0-0.15)Nd and Sn-8Zn-3Bi-(0- 0. 15)La solder melts. Wetting balance m
The gas atomization is the process that a liquid mass is disintegrated into a collection of liquid melt droplets by the impact of high velocity gas stream and s
Long afterglow phosphors MAl2O4:Eu2+, Dy3+ (M=Ca, Sr, Ba) were synthesized by microemulsion method, and their crystal structure and luminescent properties were
The influence of double aging on the microstructure and mechanical properties of ultrahigh strength steel Aermet 100 was analyzed. Under the double aging, there
An effective ensemble should consist of a set of networks that are both accurate and diverse. We propose a novel clustering-based selective algorithm for constr
An AZ61 alloy was subjected to hot compression at temperatures ranging from 523 K to 673 K,with strain rates of 0. 001 - 1 s-1. Flow softening occurs at all tem
Mixed Al-Si, Al-Si-SiC and Al-Si-W powders were employed as insert layers to reactive diffusion bond SiCp/6063 MMC. The results show that SiCp/6063 MMC joints b
The bioleaching of a marmatite flotation concentrate with a moderately thermoacidophilic iron-oxidizing bacterial strain (MLY) is influenced significantly by te
An extensive investigation was made on the effects of micro-alloying with small amounts of Sc and Mn on the microstructure and mechanical properties of the Al-M