【摘 要】
：
Cephalosporins are widely used as veterinary and human antibiotics. However, cephalosporin abuse is harmful to human health and causes allergic reactions or antibiotic resistance. We investigate a method featuring Raman spectroscopy and chemometrics to qu
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
Cephalosporins are widely used as veterinary and human antibiotics. However, cephalosporin abuse is harmful to human health and causes allergic reactions or antibiotic resistance. We investigate a method featuring Raman spectroscopy and chemometrics to quantify mixture solutions of three typical cephalosporins, namely, ceftriaxone, cefotaxime sodium, and cefazolin sodium. Partial least-squares regression models are built on spectral data that are preprocessed by various methods. With prediction relative errors within 5% and high correlation coefficients of 0.998, we demonstrate that Raman spectroscopy combined with multivariate analysis is feasible for use in the quantitative determination of cephalosporin solutions.
其他文献
对几种典型红外光谱仪,利用希尔伯特-史密特方法解积分方程能得到高分辨复原光谱,并能有效地抑制噪声影响。把较大波数范:围分成几个小区域,适当选取参数,可大大减少计算点数(～41)。对非对称核的积分方程,用修正的希尔伯-史密特方法能进一步减少计算时间和容量。该方法还可以用于增大傅里叶光谱仪的光源立体角。
给出了变栅距四面光栅的光程函数和综合像差的普遍表达式,在此基础上针对我们采用的日立变栅距平焦场四面光栅的实际参数,详细研究了它的成像性质,同时还给出了使用该光栅的平焦场光栅谱仪工作在像散和消像散两种模式下的典型实验结果。
By investigating the cross-spectral density of partially coherent multi-rotating elliptical Gaussian beams (REGBs) that propagate through a focusing optical system, we obtain the radiation force on a Rayleigh particle. The radiation force distribution is
由单侧和双侧漏模法,测量了液体和气体的折射率,将液体或气体滴入或充入棱镜和衬底之间,使这三层介质组成单侧或双侧漏波导.用棱镜耦合器测量共振漏模的模折射率,并由相应的模方程确定液体或气体的折射率.测量结果表明,折射率的误差为1～3×10~(-4).并在理论上对测量精度作了分析和讨论.
报道了一种碳氮薄膜材料的拉曼光谱,该光谱明显具有两个特征拉曼峰,和已有的碳基薄膜及碳氢薄膜相区别,其峰值位置分别位于1400cm~(-1)及1370cm~(-1)。根据X射线衍射(XRD)分析和扫描电子显微镜(SEM)对该薄膜的形貌观察,初步认定该薄膜是由纳米级含氮弯曲层状石墨结构组成。拉曼峰1400cm~(-1)对应与弯曲面内C-C振动,拉曼峰1370cm cm~(-1)对应于长程无序而形成的D-线。该碳氮薄膜样品是采用微波等离子体化学气相沉积方法(MPCVD)制备而成。
A photonic crystal fiber based surface plasmon resonance (PCF-SPR) sensor is simulated by finite element method and experimentally realized. The calculations show that there is an obvious loss peak in the vicinity of 1.2 μm while the PCF of LMA-8 is used
计算机层析成像(CL)系统对于扁平状物体的检测具有独特的优势,几何参数标定是CL系统获得高质量图像的重要步骤。现有CL系统几何参数标定方法仅能标定部分几何参数,难以一次完成所有几何参数的标定。借鉴计算机断层成像(CT)系统几何参数标定方法,提出了一种高精度的迭代标定方法,利用简单体模快速标定CL系统的所有几何参数。对CT系统几何参数标定方法用于CL系统的有效性进行分析,确定对CT系统几何参数标定方
An interesting transition between low spatial frequency laser-induced periodic surface structure (LIPSS) and high spatial frequency LIPSS (HSFL) on the surface of nickel is revealed by changing the scanning speed and the laser fluence. The experimental re