Sinter strength is dependent not only on the self-intensity of the residual rude and bonding phase but also on the bonding degree between them. The infiltration behavior of sintering liquid on nuclei ores influences the bonding degree, which ultimately determines the sinter strength. Infiltration tests were conducted using micro-sinter equipment. The infiltration area index of original liquid(IAO), infiltration volume index of secondary liquid(IVS), and sinter body bonding strength(SBS) were proposed to study the melt infiltration behavior. The results show that the IVS first increases and then decreases with increasing Ti_O2 content in adhering fines, whereas the IAO exhibits the opposite behavior. Compared with the original liquid, the secondary liquid shows lower porosity, smaller pores, and more uniform distribution. The SBS increases first and then decreases with increasing IAO and Ti_O2 content, and reaches a maximum when the IAO and Ti_O2 contents are approximately 0.5 and 2.0wt%, respectively. The SBS first increases and then tends to be stable with increasing IVS. The Ti_O2 content is suggested to be controlled to approximately 2.0wt% in low-titanium ore sintering. Sinter strength is dependent not only on the self-intensity of the residual rude and bonding phase but also on the bonding degree between them. On infiltration behavior of sintering liquid on nuclei ores influences the bonding degree, which will determine the sinter strength. The infiltration area index of the original liquid (IAO), infiltration volume index of secondary liquid (IVS), and sinter body bonding strength (SBS) were proposed to study the melt infiltration behavior. The results show that the IVS first increases and then decreases with increasing Ti_O2 content in adhering fines, whereas the IAO exhibits the opposite behavior. decreases with increasing IAO and Ti_O2 content, and reaches a maximum when the IAO and Ti_O2 contents are approximately 0.5 and 2.0 wt The SBS first increases and then tends to be stable with increasing IVS. The Ti_O2 content is suggested to be controlled to about 2.0 wt% in low-titanium ore sintering.