【摘 要】
：
Arrhenius formula was applied to calculate the apparent activation energy of zincate reaction. The standard electrode potential of all the metal coordinating io
【机 构】
：
Department of Applied Chemistry
论文部分内容阅读
Arrhenius formula was applied to calculate the apparent activation energy of zincate reaction. The standard electrode potential of all the metal coordinating ions and the order of galvanic couple of different metals in zincate solution were also calculated. Electrochemical behavior of zincate process was studied by Tafel polarization curves, E-t curves, and electrochemical impedance spectroscopy(EIS). The results show that the apparent activation energy of zincate reaction in non-cyanide multi-metal zincate solution is smaller than that in simple zincate solution, and precipitation sequence of all the metals in zincate solution is Cu,Ni, Fe and Zn. Relationship between the potential at 30 s before zincate and coverage was attained according to the change of potential of zincate. EIS shows that inductive reactance is produced during zincate.
其他文献
Amorphous silicon (a-Si) thin films were deposited on glass substrate by PECVD,and polycrystalline silicon (poly-Si) thin films were prepared by aluminum-induce
Multidoped spinel LiCo0.02La0.01Mn1.97O3.98Cl0.02 was synthesized by solid-state method. The structure and electrochemical performance were characterized by XRD
The valence electron structures of Sr- and Mg-doped LaGaO3 ceramics with different compositions were calculated by Empirical Electron Theory of Solids and Molec
Cerium phosphate powders were synthesized by direct solid liquid reaction of cerium dioxide and phosphate acid at the Ce∶P ratio of 1∶1. Phase-pure and fine g
The WC-10%Co particulate reinforced Cu matrix composite material with a WC-Co:Cu mass ratio of 20:80 was successfully fabricated by selective laser sintering(SL
Polydimethylsiloxane/polymethylacrylate(PDMS/PMA) interpenetratrating polymer networks(IPNs) was fabricated by simultaneous synthesis and characterized by therm
The TiO2 films were prepared on slides by dc reactive magnetron sputtering, then the samples were annealed at 300 ℃,350 ℃,400 ℃,450 ℃,500 ℃ and 550 ℃,resp
本文对内蒙古发展新型工业化做了SWOT(S:优势,W:劣势,O:机遇,T:威胁)分析,指出了自身的优势、劣势以及外部环境带来的机会和威胁,并在此基础上提出了发展新型工业化策略:充分
For further knowledge about the refining performance of AlTiC master alloys, Al5.5Ti0.25C and Al6.5Ti0.5C master alloys containing high Ti and C content were pr
The magnetic microstructures of 2:17 type Sm(Co,Fe,Cu,Zr)z magnets were detected by magnetic force microscopy.Comparing the microstructures of the specimens coa