传统的截除链条操作方法是将链条下面垫上一个适当大小的螺母或有孔的零件,再用平头铳了抵住销轴上端,用手锤敲击铳子,直到锁轴的端面与另一片外链板端面相平为止。按上述操作法,链条下面垫的螺母,很难与链条销轴对准,有时在锤击过程中会将所垫螺母蹦的无影无踪,在锤击过程中很难控制铳子正好把销轴端面冲到与另一片外链板的平面相平的位置,笔者针对上述操作困难,设计了一种拆截链条专用铁砧(如图),操作时很好用 The traditional way to cut off the chain is to place the underside of the chain with an appropriately sized nut or perforated part and then use a flat head to press against the upper end of the pin. The outer chain plate end up flat. According to the above method of operation, the nut of the pad under the chain is difficult to align with the chain pin, and sometimes the nut will be bounced in the hammering process without any trace during the hammering process. The pin end rushed to the plane with another piece of flat chain phase flat position, the author for the above operational difficulties, designed a split chain dedicated anvil (Figure), the operation is easy to use