In this paper, we present a programmable method of revising a finite clause set. We first present a procedure whose formal parameters are a consistent clause se
The influence of heat treating on mechanical properties as well as on the sliding wearbehavior of sintered Fe-1.SMo-0.7C steels was experimentally studied. The
In this paper we propose a sufficient condition for minimal routing in 3-dimensional (3-D) meshes with faulty nodes. It is based on an early work of the author
Clustering in very large databases or data warehouses, with many applications in areas such as spatial computation, web information collection, pattern recognit
The fracture behavior for welded joint of new generation fine grained steel SS400 wasinvestigated and assessed on the basis of fitness for purpose philosophy. T
In this paper, the parameter which is the source of the complexity of disjunctionfree default reasoning is determined. It is shown that when the value of this p
The motion of the Taylor bubbles in vertical and near-vertical tubes was investigated. The non-invasive measurements were conducted by using a high-speed motion
Quasi-isotropic laminates have isotropic elastic properties in all in-plane directions.Therefore, this kind of laminate is widely used for structural elements.
Mg-9Al-xRE magnesium alloys were studied, where x is 0, 0.4, 0.8, 1.2 and 1.6% (inweight percent, wt%), respectively. Influence of rare earths (RE) on microstru