我们曾经在“GDX-1光电跟踪线切割机”上加工了一批模具刻字小电极。我们按照图纸要求画好放大图,再取5～6mm厚的紫铜板一块,二面刨平,开启机床,利用光电跟踪原理,加工出与图纸完全相同的电极。然后用一专用夹具,加工出了与图纸相附的工件。这种专用夹具制做简单(见图),电极装夹方便,很受操作者欢迎。 We have processed a number of small mold lettering electrodes on the “GDX-1 Optical Tracking Wire Cutter”. We draw a larger map in accordance with the requirements of drawings, and then take a 5 ~ 6mm thick copper plate, two sides planing, open the machine, the use of photoelectric tracking principle, the same electrode and processing drawings. Then use a special fixture, processed with the drawings attached to the workpiece. This special fixture to make a simple (see photo), the electrode easy to install, very operator welcome.