汽车工业,电子工业和家用电器业等行业的发展,对模具制造业提出了越来越高的要求。如何用较低的成本,在较短的周期内生产出高质量、高性能的模具,成为模具制造商追求的目标。模具型面的加工,传统上一直采用仿形铣削的方法,但由于该方法的仿形过程和铣削过程必须同时进行,具有以下问题: 尽管对铣削端和扫描端的机械结构设计制造上采取了有力的措施,并不能从根本上消除铣削 Automotive industry, electronics industry and household appliances industry and other industries, the mold manufacturing industry put forward higher and higher requirements. How to use low cost, in a short period of time to produce high-quality, high-performance mold, mold manufacturers to pursue the goal. The machining of the mold surface has traditionally been using the method of profiling, but since the profiling process and the milling process of the method must be performed simultaneously, this has the following problems: Despite the mechanical design and manufacture of the milling end and the scanning end, The measure does not fundamentally eliminate milling