【摘 要】
：
Mg65Cu25Gd10 amorphous alloy powders were synthesized by mechanical alloying (MA). The most suitable process is that the milling velocity is 600 r/min and the m
【机 构】
：
Chongqing Engineering Research Center for Magnesium Alloys
论文部分内容阅读
Mg65Cu25Gd10 amorphous alloy powders were synthesized by mechanical alloying (MA). The most suitable process is that the milling velocity is 600 r/min and the mass ratio of ball to powder is 20-1, so the shortest forming time of the amorphous is about 40 h. The thermal stability of the powders was analyzed by differential scanning calorimetry (DSC). The glass transition temperature, (Tg), onset temperature of crystallization(Tx), width of supercooled liquid region, were determined to be 444.8, 531.1 and 86.3 K, respectively. Contrasting them with the parameters of samples produced by traditional copper-mold casting, it is found that the thermal stability of the former is better than that of the latter. At the same time, the crystallization kinetics of those amorphous powders was researched by Kissinger equation and the apparent activation energy at Tg and Tx was calculated.
其他文献
A self-made directional solidification setup was used to prepare high purity aluminum ingots of 100mm in diameter. The morphology of the growth interface was de
This work mainly investigated the influences of some factors, such as, synthesis methods, pre cursor alternatives, and vacuum heat-treating process, etc, on the
The creep behavior of directionally solidified (DS) superalloy IC10 was investigated under 192 MPa and 218 MPa at 980 ℃. Under the testing conditions, the mark
The main object of the present research is to make a quantitative evaluation on the microstructure of carbon materials in terms of microcrystal. The digitized i
To investigate the treating parameters influence on the surface roughness of the MAO ceramic coating on AZ91D, experiments were implemented in the alkaline elec
Al2O3/TiAl composites were fabricated by PAXD (pressure-assisted exothermic dispersion) method. The effects of Nb2O5 content on the microstructure and mechanica
Through the addition of rare earth oxides into the coating of electrodes, the high temperature oxidation and sulphidation resistance of weld metal were studied.
Effect of cooling rate on both microstructure and room temperature compressive performance of the AZ91 magnesium alloy was investigated. The experimental result
Honeycomb-like superstructures consisting of ZnS nanosheets with uniform thickness of about 20nm and lateral dimension of several micrometers were built up from
For large-sized AISI P20 steel block used as plastic die with a thickness of more than 200 mm, appropriate quenching processes are the key to obtain much thick