论文部分内容阅读
通用化、标准化、系列化,这在机械制造业中,早为人们所重视。然而,产品静力试验设备实现通用化、标准化(以下简称通标化)却是经历了一个相当长的艰难历程。最初,人们并不认为在产品静力试验设备中实现通标化有什么必要性和可能性。但在后来的试验实践中,却反复证明,试验设备不仅能够实现通标化,而且必须实现通标化。 产品的静力试验,一般说来都是任务急、时间紧。如果没有一套较完备的通标化的试验设备,那么,临时设计专用设备所占的比重必然增大,因而设备之间的协,调工作量也相应增加,资料准备周期也必然拖长。并且在设备安装过程中,还会遇到相当多的事前没有预料到的问题,这样整个试验周期也就大大的拖长,不能适应任务急时间紧的要求。
Universalization, standardization, serialization, which in the machinery manufacturing industry, as early as people pay attention. However, the product of static test equipment to achieve universal, standardization (hereinafter referred to as the standardization) is going through a very long difficult journey. Initially, one did not think it necessary and possible to standardize products in static test equipment. However, in later experimental practice, it has been repeatedly proved that the test equipment can not only achieve generalization, but also must be generalized. Static test products, in general, are urgent tasks, time tight. Without a more complete set of standardized test equipment, the proportion of temporary design-only equipment will inevitably increase. As a result, the amount of coordination and adjustment between equipment will also increase, and the data preparation period will inevitably be prolonged. And in the process of equipment installation, there will be a considerable number of unexpected problems in advance, so that the entire test period will be greatly prolonged, can not meet the urgent task of urgent requirements.