澄清池的排泥是保持泥渣平衡的关键。我厂在设计1000米~3/时机械加速澄清池中,设计了连续排泥器,实现了连续进水,连续出水,连续排泥的理想运行。1000米~3/时澄清池装设三个“污泥浓缩连续排泥器”其构造见下图。外壳用6毫米厚钢板焊制,直径D=1200毫米,筒体下部锥体圆锥角为34°;锥体下有泥渣沉积区,焊有排泥接管,装D_g100手动快开阀,其支管上装D_g32连续排泥阀。筒体上有玻璃观察窗及D_g200切向进口异径管,筒体内有60°倾 The sludge from the clarifier tank is the key to maintaining the balance of the sludge. Our factory designed a 1000m~3/hr mechanical acceleration clarifier tank and designed a continuous sludge discharger to achieve the ideal operation of continuous water intake, continuous water discharge and continuous sludge discharge. From 1000m to 3/m, the clarifiers are equipped with three “sludge thickened continuous sludge dischargers”. The structure is shown in the figure below. The outer shell is welded with 6mm thick steel plate, diameter D=1200mm, the cone cone angle of the lower part of the barrel is 34°; there is a muddy sedimentation zone under the cone, welding sludge is taken over the pipe, D_g100 manual quick opening valve, its branch pipe D_g32 continuous drain valve. The barrel has a glass observation window and a D_g200 tangential inlet reducer with 60° tilt