【摘 要】
：
In recent studies,critical research interest exists in the thermo-mechanical analysis of the friction stir welding (FSW) process by numerical simulation.In this review,the thermo-mechanical analysis for FSW is overviewed regarding the computational approa
【机 构】
：
State Key Laboratory of Tribology, Department of Mechanical Engineering, Tsinghua University, 1 Tsin
论文部分内容阅读
In recent studies,critical research interest exists in the thermo-mechanical analysis of the friction stir welding (FSW) process by numerical simulation.In this review,the thermo-mechanical analysis for FSW is overviewed regarding the computational approaches,the heat generation,the temperature,and the material flow behavior.Current concerns,challenges,and oppor-tunities in current studies are discussed considering the application of the thermo-mechanical analysis.Generally,larger computational scale and better computational efficiency are required to allow better spatial resolution in future analysis.The concepts and approaches demonstrated in the thermo-mechanical analysis for FSW open up quantitative prospects for the design of the FSW process.
其他文献
In this article the corrosion rate of the austenitic stainless steel type 304, under the synergistic effect of environmental factors has been assessed via potentiodynamic polarization scan.Salinity, velocity, pH and temperature are the factors which induc
The first-principles study of the structural,elastic and electronic properties of the M2XC phases depending on the type of M transition metal (M are Ti and Cr) and on X (X are Ga and Al) was reported.The calculations are performed using the pseudo-potenti
The effect of impurity element Fe on corrosion behavior of AZ61 magnesium alloys in various states has been investigated by immersion test and hydrogen evolution measurements in 3.5％ sodium chloride solution.The corrosion rate is found to relay on the imp
Bobbin tool friction stir welding (BT-FSW) is a variant of conventional friction stir welding (FSW).It can be used to weld complex curvature structures and closed sections by adding an extra shoulder instead of a rigid backing anvil,which expands the pote