【摘 要】
：
Effects of the process parameters, including deformation temperature, punch velocity and extrusion ratio, on the deformation and microstructure characterization
【机 构】
：
School of Materials Science and Engineering,School of Mechanical and Automobile Engineering
论文部分内容阅读
Effects of the process parameters, including deformation temperature, punch velocity and extrusion ratio, on the deformation and microstructure characterization during the semi-solid extrusion of Al-4Cu-Mg alloy, were investigated. The experimental results show that the load decreases with an increase of deformation temperature and/or a decrease of punch velocity.When the displacement is more than 4 mm, the load decreases significantly with an increase of the deformation temperature, which is related to the high liquid fraction. The microstructure varies with the process parameters and deformation regions. It can be found that the dynamic recovery occurs during the semi-solid extrusion of Al-4Cu-Mg alloy at lower deformation temperature.Subsequently, the microstructure elongated gradually polygonizes with an increase of deformation temperature. So, the higher deformation temperature should be chosen during the semi-solid extrusion of Al-4Cu-Mg alloy because the grains polygonized and high liquid fractions are beneficial to deformation.
其他文献
Pseudo-spin-valve (PSV) sandwiches using amorphous CoNbZr alloy as soft magnetic layer were fabricated by magnetron sputtering. The giant magnetoresistance (GMR
A three-layer structure back-propagation network model based on the non-linear relationship between the purity of the perovskite-type SrTiO3 nano-crystal sample
Reversible variable length codes (RVLCs) have received much attention due to their excellent error resilient capabilities. In this paper, a novel construction a
The effects of Sr element on the forming properties of the Al-Mg-Si based alloy sheets were studied by tensile test,metallograph, DSC, XRD, SEM and TEM. The res
Low cost hydride-dehydride (HDH) Ti-6Al-4V (Ti-64) alloy powder was employed to investigate the metallurgical quality and mechanical properties of laser formed
Interpenetrating phase composites (IPCs) are a new class of composite materials with improved combinations of mechanical and physical properties. This study was
The phase separation in Ni75AlxV25-x alloys incorporated with the elastic stress was investigated using the microscopic phase-field model. The final morphology
In order to examine the dependences of tensile properties of a forged Mg-13Li-X alloy on hot-rolling deformation and the underlying mechanisms tensile tests, re
China is quite poor in argent resource. Roughly 80% of this industrial argent is imported every year. In order to improve the situation, we took advantage of ra
High-resolution X-ray diffractometry (HRXRD) was used to assess the quality of 6H-SiC crystals grown by sublimation method. The results show the occurrence of l