M1432A磨床主轴外圆局部磨损后,在磨损处漏油。我们采用镶套修复主轴,效果很好。 具体方法:在轴的磨损处车一环形槽,如图所示,宽度和深度根据主轴的磨损程度而定。再车一个整圆套,材料QAl10—3—15,宽度和内径与环形槽一致,外圆留加工量。钳工把铣开的大半圆两 M1432A grinder spindles local wear, leakage in the wear Department. We use the set of repair spindle, the effect is very good. Specific methods: In the shaft wear a car-shaped groove, as shown in the figure, the width and depth according to the spindle wear degree may be. Then a whole round set of cars, materials QAl10-3-15, the width and diameter of the annular groove consistent with the amount of processing left. Fitter to open the big two semi-circular two