论文部分内容阅读
The present research is an experimental study on heat transfer characteristics of a natural circulation cooling system for electronic components. A smooth chip and two micro-pin-finned chips were tested. The chip is mounted on the base of a rectangular horizontal duct located at the bottom of 250 mm high natural circulation loop. FC-72 is used as a coolant. The test conditions are set that the operation pressure of experimental system is 1.013×10 5 Pa, the flow rate of FC-72 is 150 g/min and the subcoolings are 10 K, 25 K and 35 k, respectively. Effect of the subcooling on nucleate boiling and critical heat flux(CHF) were investigated. The results show that subcooling is found to significantly affect CHF for all chips and micro-pin-finned chips sharply enhanced the boiling heat transfer, CHF of micro-pin-finned chips are 2.5~3 times as large as that of smooth chip at the same subcooling.
The present research is an experimental study on heat transfer characteristics of a natural circulation system for electronic components. The chip is mounted on the base of a rectangular horizontal duct located at the The test conditions are set that the operation pressure of the experimental system is 1.013 × 10 5 Pa, the flow rate of FC-72 is 150 g / min and The subcoolings of 10 k, 25 K and 35 k, respectively. Effect of the subcooling on nucleate boiling and critical heat flux (CHF) were investigated. The results show that subcooling is found to significantly affect CHF for all chips and micro-pin- Finned chips sharply enhanced the boiling heat transfer, CHF of micro-pin-finned chips are 2.5 to 3 times as large as that of smooth chip at the same subcooling.