【摘 要】
：
The low melting point metallic tin powder or alloy of tin and lead was blended with polypropylene. A kind of in situ composite has been prepared.The variations
论文部分内容阅读
The low melting point metallic tin powder or alloy of tin and lead was blended with polypropylene. A kind of in situ composite has been prepared.The variations of torque were studied when the composites were mixed in Haake torque rheogeniometer. By way of capillary extrusion, effects upon rheology of the in situ composites of the low melting point metals (LMPM) and coupling agent for their different variety and content,were investigated. From flow curves, the results indicate that in situ composites mixed with the LMPM are a kind of pseudoplastic fluid. If the LMPM were melted,the higher the content of the LMPM, the lower apparent viscosity of composites.Meanwhile,when the coupling agent is added into composites,the viscosity of composite will go up first and drop then. This shows that the LMPM have a promoter flow action on the polypropylene.
其他文献
In this work the electronic structure and the impurity excess of the basal and rhombohedral twin grain boundaries are investigated, using electron energy loss s
Four sensing membranes based on fluorescence quenching were prepared by sol-gel method and CA membrane method,and the Ru(Ⅱ) complexes,Ru(bpy)3Cl2 and Ru(phen)3
The samples of pure Fe were treated by surface gas-phase RE permeation plus laser melting solidification (LMS). The microstructures were observed by Scanning El
Glasses of BaO-SrO-TiO2-SiO2 after electronic radiation treatment of 50-1000 kgy were studied by means of IR spectra, DTA and visible light absorption method.Th
In this paper, the interaction curves of acoustic and optical waves in a non-collinear AOTF (acousto-optic tunable filter) cell under the parallel-tangent momen
随着中国经济的成长以及金融业发展国际化的潮流,中国商业银行迈出了国际扩张的步伐,在此过程中投资策略的选择非常重要.本文用SWOT分析法分析了并购与新建投资两种模式,初步
All natural and living systems are governed by atomic and molecular behavior at the nanoscale. Research is now seeking systematic approaches to create revolutio
Single-walled carbon nanotubes (SWNTs) were synthesized by a hydrogen arc discharge method. A high yield of gram quantity of SWNTs per hour was achieved. Tow ki
Using specially coated mirrors, an output energy of 0.97 J at 1.32 μm from a Nd3+∶YAG pulse laser is obtained with pumping energy of 66 J. The repetition rate
Stresses in epitaxial and textured Al films were determined by substrate-curvature measurements. It was found that in both cases the flow stresses increase with