论文部分内容阅读
基于二维带输运模型,研究了LiNbO3:Fe晶体中光束从自散焦向自聚焦动态转换过程.结果表明暗辐照在动态转换过程中起着非常重要的作用,当暗辐照较小时动态转换过程才发生.在暗辐照较小的情况还分析了热释电效应对动态转换过程的影响.
在LiNbO3:Fe晶体中暗辐照对光束从自散焦向自聚焦转换过程的影响
【摘 要】
：
基于二维带输运模型,研究了LiNbO3:Fe晶体中光束从自散焦向自聚焦动态转换过程.结果表明暗辐照在动态转换过程中起着非常重要的作用,当暗辐照较小时动态转换过程才发生.在暗
【机 构】
：
南开大学物理学院,天津理工学院自动化系
【出 处】
：
物理学报
【发表日期】
：
2004年期
【基金项目】
：
国家自然科学基金;
其他文献
The Study of Deposition Parameters, Properties for PVD TixN and CrxN Coatings Using a Closed Field U
Closed Field Unbalanced Magnetron Sputter Ion Plating (CFUBMSIP) systems have been used increasingly for PVD coating in recent years. TiN and CrN coatings, comm
In the present work, attempts have been made to extend the use of the tribological and chemical properties of rutile-TiO2 to metallic alloy systems, by forming
Direct Electroless Nickel Plating on AZ91D Magnesium Alloy from a Sulfate Solution and its Depositio
A bath of electroless plating Ni on the AZ91D magnesium alloy, containing sulfate nickel, was given in this paper. The nucleation mechanism of Ni-P deposits on
This paper gives a short introduction to the typical process route and material properties of these steels in comparison to standard martensitic corrosion-resis
A reasonable pre-treatment and an ultrasonic pre-plating Cu film were applied for sintering NdFeB permanent magnet. The samples were then plated in neutral bath
Influnce of Stoichiometry and Molar Ratio of Barium Ferrite Thin Film Synthesized by Sol-gel on Alum
Amorphous gels were processed with a varying Fe/Ba ratio of 11/5, 28/2, 10.5/1 in water and Solvent. Iron and barium nitrites with specific molar ratio was solv
Effect of Cd and Sn Addition on the Microstructure and Mechanical Properties of Al-Si-Cu-Mg Cast All
The present work has investigated the effect of trace elements Cd and Sn on the microstructure and mechanical properties of Al-Si-Cu-Mg cast alloy. With the inc
In the present reserch, a model has been proposed for estimate fracture toughness of Nickel-phosphorus (EN) layers. For this purpose, high phosphorus (9%) EN co
Nowadays, in the auto industry, the need for improvement of fuel efficiency is getting increased more and more in terms of the global warming, as well as the ne
Effect of Zr Addition on Resistance to High Temperature Softening and Resistivity of 6082 Al-Mg-Si A
The influence of zirconium on the resistance to high temperature softening of 6082 Al-Mg-Si alloys has been researched. The softening process of 6082 alloys wit