我厂钻头车间钻头磨尖工序糊刃问题,历年来一直没有得到解决,因此钻头质量较差,成为钻头制造中的关键。在这次技术革新运动中,仅化16小时就解决了。 原先钻尖是干磨的,后来会利用乳化油做冷却液来进行磨刀,由于刃磨时,有很多乳化油贴在钻头上,使操作者观察刃磨情况比较困难,往 I plant drill bit sharpening drill bit shop process problems, over the years has not been resolved, so the poor quality of the drill bit, a drill bit in the manufacture of the key. In this technological innovation movement, only 16 hours have been solved. The original drill point is dry grinding, and later will use emulsified oil to make coolant, because the sharpening, there are a lot of emulsified oil attached to the drill, so that the operator to observe sharpening more difficult to