论文部分内容阅读
目的对医院病床工作效率进行准确的评价与质量控制。方法采用校正病床工作效率值的方法对某院病床工作效率进行综合评价与质量控制:(1)以2006~2008年各月每床日均出院人数×平均病床使用率算得校正的病床工作效率值(EF′),作为建模训练样本。(2)2009年各月数据为控制样本。(3)绘制可信区间质控图。结果 2009年的12个EF′值点子中,1月、2月和10月的EF′值略低于EF′值,其余9个月的EF′值均在EF′值之上,12月EF′值最高,达到最好水平。结论该院2009年病床工作效率较高,其病床利用状态处于较高利用水平。
Objective To evaluate the accurate and quality control of the hospital bed efficiency. Methods The method was used to evaluate the working efficiency of a hospital bed by using the method of calibrating the working efficiency of the hospital bed. (1) Based on the average number of hospital beds per bed per day from 2006 to 2008 × the average bed occupancy rate, the corrected bed work efficiency (EF ’) as a modeling training sample. (2) The monthly data of 2009 is the control sample. (3) draw confidence interval control chart. Results Among the 12 EF ’s in 2009, EF’ values in January, February and October were slightly lower than EF ’values. EF’ values for the remaining 9 months were all above EF ’values. In December EF ’Highest value, to achieve the best level. Conclusion The hospital beds in 2009 higher efficiency, utilization of the bed at a higher level of utilization.