论文部分内容阅读
Directly Modulated 10 Gb/s Signal Transmission over 320 km of Negative Dispersion Fiber for Regional
【机 构】
：
KoreaAdvancedInstituteofScienceandTechnology373-1Gusong-dong,Yusong-gu,Daejon305-701,KoreaSamsungEle
【出 处】
：
光学学报
【发表日期】
：
2003年23期
其他文献
Efficient pulsed chemical oxygen-iodine laser with instantaneous generation of atomic iodine by volu
A pulsed chemical oxygen-iodine laser (COIL) using atomic iodine generated by volumetric discharge of CH3I is developed and tested. COIL with a gain length of 60 cm is energized by a square pipe-array jet singlet oxygen generator with basic hydrogen perox
By using mercaptopropyltrimethoxysilane (MPTS) self-assembled monolayers (SAMs), electroless silver plating is developed for the metallization of near-field optical fiber probes. This method has the advantages of controllability, no pinholes, convenience,
A new but simply implemented optical clock recovery scheme for optical time-division multiplexing (OTDM) systems based on stimulated Brillouin scattering (SBS) effect is presented and demonstrated experimentally. According to the unequal-amplitude even-mu
Noninvasive technology for measuring instantaneously two-dimensional (2D) temperature distributions of flame using two-color planar laser induced fluorescence (PLIF) of OH is investigated. A calibration method is researched and developed. This method is b
本文以激光场与液体中分子间键的相互作用为基础,提出了激光作用下液面分层气化的模型,并导出了分层气化的理论公式。用波长为10.6μm的CO2激光对纯水、丙酮和乙醇液面进行照射,实验测得液面每层气化所需的时间分别为1.28×10-3s、9.57×10-4s和1.05×10-3s。实验结果与理论符合。
期刊
In this letter, we propose a method for the numerical calculations of the femtosecond laser pulse passed through a subwavelength aperture. The time-dependent laser pulse is decomposed into a series of monochromatic simple harmonic waves.For the light fiel
A diode-end-pumped electro-optic (EO) Q-switched green laser operating at the repetition rate of 20 kHz is reported. A block of La
针对光刻机照明系统的实际应用需求,提出了一种光瞳特性参数的评估算法。该算法通过对光瞳强度分布进行转换,可以在不同照明模式下同时计算光瞳椭圆度、X 方向光瞳极平衡性、Y 方向光瞳极平衡性和四象限光瞳极平衡性等多种光瞳特性参数。以一种28 nm节点扫描光刻机照明系统的中继镜组为实例,对其在传统照明模式下进行光瞳特性参数计算分析。仿真结果显示,全视场光瞳椭圆度最大值为0.95%,X 方向和Y
设计了一种新型的散射元圆弓形散射元。以此散射元为基础，在硅片上制作出多种介质柱和空气孔型光子晶体波导。测量表明：圆弓形介质柱结构，较空气孔结构更有利于带隙的形成，而且随着参数e的改变，会引起光子禁带大小和位置的改变。对于同一介质柱结构，随着入射光与长轴夹角的增大，其反射谱中禁带的位置产生明显蓝移，反映出这一结构的各向异性特征。