磷钼蓝光度法测定钼

来源 :分析试验室 | 被引量 : 0次 | 上传用户:sdwfzhd
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
利用磷钼杂多酸测磷,这是众所周知的,但用于钼的测定,还未见报道。本文提出在含MoO_4~(2-)溶液中,过量PO_4~(3-)的存在下使之形成磷钼杂多酸,经抗坏血酸还原后,直接用于钼的测定,方法十分简便。在测定波长690nm处,摩尔吸光系数为7.0×10~2,钼量在0—12mg/mL范围内符合比尔定律,满足高含量钼快速分析的要求。方法用于钼铁中钼的测定,获得较为满意的结果。 Phosphorus molybdenum heteropoly acid measured phosphorus, which is well known, but for the determination of molybdenum has not been reported. In this paper, it is proposed that the method of forming molybdophosphoric heteropoly acid in the presence of excessive PO 4 - (3-) in MoO 4 ~ (2-) solution is directly used for the determination of molybdenum after reduction with ascorbic acid. The method is very simple. The molar absorptivity is 7.0 × 10 ~ 2 at the wavelength of 690nm and Beer ’s law is obeyed in the range of 0-12mg / mL, which satisfies the requirement of rapid analysis of high content of molybdenum. The method was applied to the determination of molybdenum in ferromolybdenum, and the satisfactory results were obtained.
其他文献
本文介绍了PEG-20M极性交联毛细管柱的主要性能,此柱具有良好的热稳定性及溶剂不可抽提性,尤其是对水的不可抽提性,并成功地将其用于香料、药物及石油化工产品的分析,分析酒
本文认为,集中力量进行社会主义经济建设,必须立足国情,着重解决好事关我国经济发展大局的一些主要问题。为此,一是要把科学技术和教育事业放的首位,使经济建设转移到依靠科
Based on step-by-step microscopic calculation, the regular pumping one-atom micromaser is studied when the cavity decay in interaction time is considered. By nu
本文研究了30crMnsi钢调质一旋压一时效的形变热处理新工艺。钢材由供应状态先行淬火与高温回火(调质),然后进行形变量为50%的旋压和低温时效处理。旋压和时效使钢材抗拉强度
高速钢刀具的氧氮化,是在530~580℃下的氨和水蒸气的混合气氛中进行的热化学处理,使刀具表面形成一层氧氮化层,表层是磁性氧化铁膜,内层是氧氮扩散层。表层氧化膜能保存润滑
一、轧尖机1.用途:在钢丝穿模时用轧尖机将线材或钢丝端头锻细。2.分类:按原理分有两种类型,即锻打式和压延式。(1)迥转式锻尖机(一般叫旋锤)——锻打式 First, the rollin
我厂生产的汽轮机主汽门的15Cr11MoV钢阀杆、阀碟等零件,氮化后要求 HV≥650,渗层深度≥0.30mm,脆性≤3级。原采用普通氮化:530±10℃×20h,氨分解率25~30%;600±10℃×37h,
迄今,在金的萃取化学研究中,以中性含氧萃取体系为最多。我们曾对含有碳氧、硫氧和磷氧的萃取剂对金的萃取作过报道,新近,又有芳香氮氧化物用于金和铂族金属的萃取研究和金
本文就ISO关于分析试剂中砷的测定的一般方法作了理论上的详细说明。 This paper gives a detailed description of the general method of ISO for the determination of a