论文部分内容阅读
1.调整 (1)传递动力皮带紧度调整松开上连接臂连接螺钉,变换固定孔,使皮带达到适当紧度后拧紧连接螺钉。 (2)上下输送带紧度调整调整被动皮带轮调节螺钉,直到输送带没有自然下垂为止,但不宜过紧。 (3)上输送带高度调整松开左右两皮带轮顶丝,沿皮带轮轴上下调整皮带轮。小麦高时向上调,小麦矮时向下调,注意保持皮带的水平和紧度。
1.Adjustment (1) Transmission power belt tightness adjustment Loosen the upper connecting arm connecting screw, change the fixing hole, make the belt reach the appropriate tightness and tighten the connecting screw. (2) adjust the tightness of the upper and lower conveyor belt Adjust the passive pulley adjustment screw until the conveyor belt does not hang naturally, but should not be too tight. (3) adjust the height of the conveyor belt Loosen the top and left two pulleys, adjust the pulley up and down along the pulley shaft. Turn up when the wheat is high, the wheat is dwarfed down, pay attention to keeping the level and tightness of the belt.