• 不 限
  • 期刊论文
  • 硕博论文
  • 会议论文
  • 报 纸
  • 英文论文
  2. 您的位置
  3. 首页
  4. 期刊论文
  5. Distribution of SiC particles in semisolid electromagnetic-mechanical stir-casting M-SiCcomposite

Distribution of SiC particles in semisolid electromagnetic-mechanical stir-casting M-SiCcomposite

来源 :中国铸造：英文版 | 被引量 : 0次 | 上传用户：csmale
【摘 要】
：
The distribution of SiC particles in AI-SiC composite can greatly influence the mechanicalperformances of AI-SiC composite. To realize the homogeneous distribut
【作 者】
：
Yun-hui Du Peng Zhang Wei-yi Z 
【机 构】
：
SchoolofMechanical
【出 处】
：
中国铸造：英文版
【发表日期】
：
2018年5期
【关键词】
：
AI-SiC composite STIR CASTING PARTICLE DISTRIBUTION microstructure performance A 
【基金项目】
：
This work was financially supported by the Beijing Natural Science Foundation （No. 2162036）.
下载到本地 , 更方便阅读
下载此文 赞助VIP
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The distribution of SiC particles in AI-SiC composite can greatly influence the mechanicalperformances of AI-SiC composite. To realize the homogeneous distribution of SiC particles in stir-casting AI-SiCcomposite, semisolid stir casting of AI-4.25vol.%SiC
其他文献
Microstructure and properties of ductile iron bars for plunger pump prepared by horizontal continuou
Ductile iron bars(DIBs) with a diameter of 145 mm, used for plunger pump production, were made by the horizontal continuous casting(HCC). The microstructure of
期刊
HORIZONTALcontinuouscastingDUCTILEironBARSPLUNGERpumptensionandTORSION
Microstructure and properties of TP2 copper tube with La microalloying by horizontal continuous cast
TP2 铜试管被水平连续的扔与 La microalloying 准备(HCC ) 。微观结构上的 La 和它的效果的吸收率，张力并且 HCC TP2 铜试管的腐蚀性质借助于诱导地联合的血浆被学习光排放分
期刊
Analysis of the residual stress in Al<sub>2</sub>O<sub>3</sub>-SiC nanocompo
The residual stress in Al<sub>2</sub>O<sub>3</sub>-SiC nanocomposites was measured by the X-ray diffraction method. A mode was established to calculate the resi
期刊
NANOCOMPOSITERESIDUALstressA1<sub>2</sub>O<sub>3</sub>
Microstructure and superelasticity of porous NiTi alloy
The microstructure, porosity, phase composition and superelasticity (SE) in porous NiTi alloys produced by elemental powder sintering are examined by SEM, image
期刊
POWDERSINTERINGPOROUSALLOYNITIshapememoryALLOYsuperelasticity.powder si
Preparation of a new animal glue binder for foundry use
A new casting binder was prepared based on an animal bone glue. In order to overcome the disadvantages of the animal glue agglomeration at room temperature, an
期刊
animalgluealkalinedecompositionMODIFICATIONgraftcopolymerizationETHERIFIC
Principle of uniformity of temperature difference field in heat exchanger
A principle of uniformity of temperature difference field (TDF) in heat exchangers is advanced.It states that the more uniform the temperature difference field,
期刊
TDFofheatEXCHANGERUNIFORMITYofTDFEFFECTIVENESSENTROPYgeneration.TDF of
Microstructure and mechanical properties of AZ91 magnesium alloy with minor additions of Sm, Si and
The effects of Sm, Si and Ca on the microstructure and mechanical property of AZ91 magnesium alloy were investigated by means of optical microscopy (OM), differ
期刊
AZ91SMCa/SiGRAINREFINEMENTmechanicalproperties
Effects of Cu addition on microstructureand mechanical properties of as-cast Mg-6Znmagnesium alloy
The application of Mg-Zn binary alloys is restricted due to their developed dendritic microstructure andpoor mechanical properties. In this study, an alloying m
期刊
MG-ZNmagnesiumALLOYCUADDITIONmicrostructureMECHANICALpropertyfracturemo
Effects of ZnS modification on primary Si in hypereutectic Al-Si alloy
一个新修改代理人， ZnS，当，被使用一对更精制在高级低共熔体的 Al-Si 修改主要的硅合金。包括 ZnS 和成立时间的增加水平，影响修正结果的因素被调查。结果证明最有效地修改的主要
期刊
ZNS主要的硅高级低共熔体的Al-Si合金修正TG146.21AZnS primary silicon hypereutectic Al-Si
Effect of fluid flow on solidified equiaxed dendrite morphology evolution based on phase field-latti
Fluid flow can significantly change the evolution of microstructural morphology. However, relatively little is known how the fluid flow, concentration and micro
期刊
phasefieldlatticeBOLTZMANNmethodFORCEDflowinstability