论文部分内容阅读
先拆下光驱的前面板,看到光驱弹出门部分的积尘。此处的积尘最多,一般成块状,可用棉棒将此部位清洁干净。再打开光驱壳盖,依厂家不同,有时需将光驱机芯整个从光驱外壳上拆下来,才能观察到光盘托架的中央部分。(在拆卸过程中,特别注意不要误将光驱的控制电路板从光驱机芯上拆下来!)现在可以把能观察到的积尘先擦干净。在清洁过程中,若发现光盘托架运动滑道上的润滑油太脏,可将其擦掉后另加少许优质润滑油。然后将已打开外盖的光驱电源线、扁平数据线与主机连好,此时光驱的电路板若外露,应注意绝缘,以防电路短路。确
First remove the CD-ROM front panel, see the drive pop-up part of the dust. Here’s the most dust, usually into lumps, cotton swabs can be used to clean this site. Then open the drive housing cover, according to different manufacturers, and sometimes need to drive the whole movement from the CD-ROM drive shell removed in order to observe the central part of the disc tray. (During disassembly, pay special attention not to remove the CD-ROM’s control board from the CD-ROM drive!) Now it is possible to wipe off the observed dust. In the cleaning process, if found on the disc tray movement chute lubricating oil is too dirty, it can be rubbed off with a little high-quality oil. Then open the outer cover of the optical drive power cord, flat data line with the host even good, then if the optical drive circuit board exposed, should pay attention to insulation to prevent the circuit short circuit. Indeed