Unraveling the surface chemistry processes in lithiated and boronized plasma material interfaces und

来源 :MatterandRadiationatExtremes | 被引量 : 0次 | 上传用户:wjh198004546
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The review of recent theoretical and experimental research on the complex surface chemistry processes that evolve from low-Z material conditioning on plasma-facing materials under extreme fusion plasma conditions is presented. A combination of multi-scale computational physics and chemistry modeling with real-time diagnosis of the plasma-material interface in tokamak fusion plasma edge is complemented by ex-vessel in-situ single-effect experimental facilities to unravel the evolving characteristics of low-Z components under irradiation. Effects of the lithium and boron coatings at carbon surfaces to the retention of deuterium and chemical sputtering of the plasma-facing surfaces are discussed in detail. The critical role of oxygen in the surface chemistry during hydrogen-fuel irradiation is found to drive the kinetics and dynamics of these surfaces as they interact with fusion edge plasma that ultimately could have profound effects on fusion plasma confinement behavior. Computational studies also extend in spatio-temporal scales not accessible by empirical means and therefore open the opportunity for a strategic approach at irradiation surface science studies that combined these powerful computational tools with in-vessel and ex-vessel in-situ diagnostics.
其他文献
期刊
采用全量子理论和数值计算方法,研究了初始处于相干态的双模腔场与一个V型三能级原子共振相互作用的压缩特性,讨论了在没有对原子进行态选择测量、直接对原子进行态选择测量和应用经典微波场并对原子进行态选择测量的三种情况下,腔模平均光子数、耦合系数以及相互作用时间对压缩特性的影响。证明了压缩随着两个腔模光子数的增加而增加,而且通过对原子进行态选择性测量可以使压缩大大地增强,即使少光子数也一样。综合所有情形,发现最大压缩可以接近75%。
SiC coating for surface modification grows on reaction boned SiC (RB-SiC) substrate cannot have high quality because the material of RB-SiC has two phases. We apply a new method to improve the effect of surface modification. First the surface of RB-SiC is
针对激光器线宽对空间相干光通信系统性能的影响,提出了激光器线宽影响空间相干光通信链路传输误码率的计算方法。研究了湍流大气中激光器线宽对链路传输误码率的影响,建立了大气湍流中空间相干光通信链路传输误码率模型。分析了不同参数影响下激光器线宽对误码率的影响,通过计算发现,线宽增大1倍,误码率增加2.7倍左右;线宽增大一个数量级,相应的误码率也增大近一个数量级。
本文引入满足均匀矢量亥姆霍兹方程的矢量波函数作为基矢,对矩孔光栅的孔内外光场分别进行矢量模式展开和矢量平面波展开,并由耦合条件导出了求解展开系数的方程组,从方程组中求解出相应的振幅系数,可研究光栅的衍射场分布.该方法可研究入射场方向和偏振任意时的衍射效率和偏振特性等问题.
介绍了机载环境下紫外像增强管的几种典型早期失效问题, 对失效机理进行了分析, 提出了消除失效隐患的对策措施。实践证明, 采取对应措施后, 某型紫外像增强管的早期失效率显著下降。
作为空间可见光相机的主要承载结构,机身桁架结构对于保证机身的力学性能至关重要。为了保证空间相机机身的结构刚度和稳定性, 针对机身桁架结构设计进行了研究。研究了桁架的基本结构,分析了支杆力学性能的影响因素,探讨了支杆长度和角度对该机身桁架力学性能的影响。分 析了支杆数量、支撑位置和分布形式对机身力学性能的影响,并分析了“Δ”型和“X”型桁架结构的特点。通过选择合理的支杆数量和分布形式,保 证了机身桁架的力学性能。然后在设计分析的基础上进行了力学试验,验证了机身的力学性能。试验结果表明,该桁架结构的设计能够获
As an extension of the Mie lidar technique to measure the extinction coefficient of the surface particles, a horizontally pointing Mie lidar is used for determining the optical properties of Asian dust, which is an approach without knowing the actual lida
表面等离激元弯曲光束(SPB)作为一种局域在金属表面传输的特殊光束,在光子操控和光学捕获等方面有着特殊的应用潜力。应用相位匹配法,设计了几种金属纳米狭缝阵列(V形、N形、M形及M V形)结构,调控产生了SPB;讨论了入射光波偏振角度和结构参数对SPB电场强度的调控影响。以M形结构为例,讨论了结构臂之间的夹角、结构参数及结构间的耦合对SPB的影响。结果表明:不同结构产生的SPB电场强度随入射光波偏振角度的变化满足正弦函数分布;SPB电场强度分布受到结构臂之间的夹角、结构参数及结构间的耦合影响。用偶极子远场辐
A novel microring resonator sensor coated with a single negative metamaterial (SNM) layer is proposed. The dispersion relation of hollow cylindrical dielectric waveguide covered with a SNM layer is derived, and resonant frequencies of the corresponding wh