【摘 要】
：
The aluminium tubes with high strength and smooth outer-surface can be produced by non-mandrel drawing process. It is an effective method to study forming mecha
【机 构】
：
College of Mechanical Engineering
论文部分内容阅读
The aluminium tubes with high strength and smooth outer-surface can be produced by non-mandrel drawing process. It is an effective method to study forming mechanism of drawing process by simulation, based on which the relevant dies with reasonable dimensions can be designed to ensure tube precision. The dynamic model and elasto-plastic finite element model of the forming process were established based on FEM software Deform-3D, then the simulation was performed. The expressions about drawing load were deduced, and the influence of friction coefficient on drawing load was computed by the expressions and software respectively. Based on simulation results the deformation mechanism of drawing process without plug was expounded. According to flowing speed vector graph the law of material flowing was summarized, by which the deformation regions were partitioned.Furthermore, some potential problems of drawing process such as diameter shrinking, thickness varying were forecast and analyzed quantificationally.
其他文献
Bulk Sm2Fe17Nx sintering magnet was fabricated by spark plasma sintering(SPS) technique. The effects of sintering pressure and sintering temperature on the magn
The rare earths of ytterbium, lanthanum, praseodymium, neodymium and their binary mixtures were respectively added into the traditional electroless plating solu
The effects of rare earth element cerium on composition and electrochemical characteristics of electroless Co-Ni-B alloy were studied in this paper. The alloy c
The preparation technics of glass-ceramics with super low coefficient of thermal expansion containing β-quartz solid solution as a main crystal phase based on
Optically transparent alumina ceramics were fabricated by conventional process and sintered without pressure in H2 atmosphere. The results indicate that relativ
The chemical vapor(CVD) deposition-diffusion method was applied to prepare FeSi alloys with high silicon content up to 6.5%. In spite of various deposition and
Using embedded-atom-method potential for Pd and MORSE potential for the interaction between H and Pd atoms,the adsorption properties of H atoms on Pd (211),(311
The highly pure nano-crystal Mg,Al-hydrotalcite with titania doping was synthesized by one-step liquid reaction method at atmospheric pressure. The preparation
Solvothermal technique, an one-step soft solution-processing route was successfully employed to synthesize single crystalline CdS nanowires in ethylenediamine m
The effect of cooling rate on the solidification process of Al-2.06%Si-1.58%Mg was numerically and experimentally investigated. The solidification paths and the