论文部分内容阅读
以前,一直对液压机有某种程度的怀疑。由于担心它会泄漏、速度低,不能用予冲裁加工等原因,因此一直倾向用于拉深和装配加工。然而,这种倾向现在正在改变。在 Leamington 板金工程学会(ISME)的一次周未会上,BL Cowley 的 D.J.Simpson 博士提出了一篇非常精采的文章。它描述了在选择机械压力机和液压机时应考虑的一些因素,此外,在Cowley、Swindon 和 Llanelli 冲压件厂中液压机在板材生产线上的应用证明了这些因素,对
In the past, there was some degree of doubt about the hydraulic press. Because of its fear of leakage, low speed, can not be used for blanking and other reasons, it has been inclined to drawing and assembly processing. However, this tendency is now changing. At a weekly meeting of the Leamington Sheet Metal Engineering Society (ISME), Dr. D. J. Simpson of BL Cowley presented a brilliant article. It describes some of the factors that should be considered in the selection of mechanical and hydraulic presses. In addition, the use of hydraulic presses in sheet metal production lines at the Cowley, Swindon and Llanelli press plants proves these factors,