论文部分内容阅读
One important problem in casting wrought aluminum alloys is the high tendency to the formation of hot tears in the solidification process.By using semi-solid metal(SSM) processing,the hot tearing tendency of alloys can be minimized during casting.In the present research,the semi-solid slurry of wrought aluminum alloy 2024 was firstly prepared with a novel self-inoculation method(SIM),and then the microstructure characteristics of the semi-solid slurry and the rheo-diecastings cast with the semi-solid slurry were investigated.The results indicate that finer and more uniform globular primary α-Al particles can be obtained when the semi-solid slurry are isothermally held for a short period within the semi-solid temperature range,and the primary α-Al particles without entrapped liquid are uniformly fine,globular grains in the rheo-diecastings.The holding temperature and time affect the solid fraction,particle size,and shape factor.After the semi-solid slurry is held at 625 ℃ for 3 min and 5 min,the optimal values for the average equivalent diameter are 70.80 μm and 74.15 μm,and for the shape factor are 1.32 and 1.42,respectively.The solidification process of the rheo-diecastings is composed of the following two distinct stages:primary solidification process and secondary solidification process.The secondary solidification process consists further of the following three stages:(1) direct growth of secondary primary(α 2) phase from the surface of the primary α-Al phase particles without re-nucleation,(2) independent nucleation and growth of α 3 phase from the residual liquid,and(3) eutectic reaction at the end.
One important problem in casting wrought aluminum alloys is the high tendency to the formation of hot tears in the solidification process. By using semi-solid metal (SSM) processing, the hot tearing tendency of alloys can be minimized during casting. In the present research , the semi-solid slurry of wrought aluminum alloy 2024 was first prepared with a novel self-inoculation method (SIM), and then the microstructure characteristics of the semi-solid slurry and the rheo-diecastings cast with the semi-solid slurry were investigated The results indicate that finer and more uniform globular primary α-Al particles can be obtained when the semi-solid slurry are isothermally held for a short period within the semi-solid temperature range, and the primary α-Al particles without entrapped liquid are uniformly fine, globular grains in the rheo-diecastings. The holding temperature and time affect the solid fraction, particle size, and shape factor. After the semi-solid slurry is held at 625 ° C. for 3 min and 5 min, the optimal values for the average equivalent diameter are 70.80 μm and 74.15 μm, and for the shape factor are 1.32 and 1.42, respectively. The solidification process of the rheo-diecastings is composed of the following two distinct stages: primary solidification process and secondary solidification process. The secondary solidification process consists of the following three stages: (1) direct growth of secondary primary (α 2) phase from the surface of the primary α-Al phase particles without re-nucleation, (2) independent nucleation and growth of α 3 phase from the residual liquid, and (3) eutectic reaction at the end.