eutectic相关论文
Freeze drying or lyophilization of aqueous solutions is widely used in pharmaceutical industry.The increased importance ......
以低熔点金属(Ga,In,Sn)作为合金元素,采用机械球磨法制备Al-In-Sn和Al-Ga-In-Sn合金。研究In和Sn的质量比以及Ga的含量对铝合金水......
DEPENDENCE OF MICROSTRUCTURE SCALES OF EUTECTICS ON Ca-Si MODIFIER AMOUNT IN AUSTENITE STEEL COMPOSI
Results presented in this paper contribute to investigation of the effect of the added Ca-Si modifier amount (αk) on th......
SnCu solder is one of the most promising substitutes of SnPb solder, but its creep resistance is worse than that of the ......
This paper seeks to optimize parameters, reduce the cost of desulphurization and the consumption of operation about KR p......
Through the vacuum diffusion welding SiCp/ZL101 aluminum with Cu interlayer,the effect of welding parame-ter and the th......
We present a micro-Pirani vacuum gauge using the low-resistivity monocrystal silicon as the heaters and heat sinks fabri......
Effects of micro-amount of rare earth Ce on microstructures of Sn-3.0Ag-0.5Cu solder alloy were studied. The results ind......
For the development of fiber optics for the range from 0.2 to 50.0 μm, one needs light-stable, nonhygroscopic,ductile c......
The developed 1Cr18Ni9Ti austenitic stainless steel containing 1.63 wt.%B have been characterized by X-ray diffraction(X......
Note:This book consists of five sections:Chapter 1 Introduction,Chapter 2 Grey Iron,Chapter 3 Spheroidal Graphite Cast I......
Deformation mechanism and forming properties of 6061Al alloys during compression in semi-solid state
The 6061 semi-solid aluminium alloy feedstocks prepared by near-liquidus casting were compressed in semi-solid state by ......
The decomposition of the coarse primary M_2C carbide in M2 high speed steel was investigated by using optical microscope......
The microstructural evolution and interfacial reaction of the Au/Sn/Au/Sn/Au/Sn/Au couples were investigated during anne......
Note:This book consists of five sections:Chapter 1 Introduction,Chapter 2 Grey Iron,Chapter 3 Ductile Iron,Chapter 4 Ver......
The effect of rare earths on the morphology and microstructure of eutectic carbides in M2 high speed steel was studied. ......
The microstructure of hot-dip galvanized Zn-11%Al-3%Mg-0.2%Si alloy coating was studied in this article.X-ray diffractio......
The effect of the rare earth element Er on the microstructures and properties of Mg-Al intermetallic were studied in thi......
Based on the Cu-Zr-Ti ternary phase diagram,four sets of Cu-Zr-Ti multilayered films with various compositions of Cu20Zr......
The effect of Gd modification on the microstructure and mechanical properties of A356 aluminum alloys was investigated u......
对真空压铸Al-Si-Cu合金试样(500 mbar)和普通压铸Al-Si-Cu合金试样在500℃固溶处理0.5、2、4、6 h后,利用光学显微镜及相应软件研......
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
Solid-liquid equilibrium of dimethyl terephthalate(DMT),dimethyl isophthalate(DMI)and dimethyl phtha
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
选取Ti/Au作为金属过渡层来实现低温硅-硅共晶键合。首先介绍了共晶键合的基本原理,分析了选择金-硅共晶键合的原因,设计了单面溅......
Study on the Relationship between Lamellar Spacing and Growth Rate in the Regular Eutectic Growth by
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
A new procedure was proposed for evaluating the weldability of nickel-base superalloys.The theory is on the basis of two......
Effect of arsenic content and quenching temperature on solidification microstructure and arsenic dis
The solidification microstructure, grain boundary segregation of soluble arsenic, and characteristics of arsenic-rich ph......
Evolution of insoluble eutectic Si particles in anodic oxidation films during adipic-sulfuric acid a
The effects of insoluble eutectic Si particles on the growth of anodic oxide films on ZL114 A aluminum alloy substrates ......
Fabrication of wear-resistant layers with lamellar eutectic structure by laser surface alloying usin
该文从挂篮荷载计算、施工流程、支座及临时固结施工、挂篮安装及试验、合拢段施工、模板制作安装、钢筋安装、混凝土的浇筑及养生......
The microstructure of experimental nickel-base single crystal superalloys with different levels of carbon has been studi......
This paper reports the investigation results on directional growth of Al-Mg_2Si eutecticalloy in the SZ2 unmanned space......
The microstructure of the as-cast, as-solution-treated and as-aged wrought magnesium alloy ZK60 was studied. The results......
The evolution of the microstructure and phases of the direct chill semicontinuous casting ingot of 7B04 super-high stren......
In the Cu-Zr-Ti ternary system, a new composition zone of bulk metallic glasses (BMGs) formation was discovered, locatin......
采用热分析、光学显微镜技术、扫描电镜技术、聚焦离子束和能量色散谱分析方法研究Ce对Al-Si-Cu合金中α(Al)-Al2Cu共晶形貌的影响......
Processing, microstructure, and properties of laser remelted Al2O3/Y3Al5O12(YAG) eutectic in situ co
Laser remelting and rapid solidification were performed in preparing the high-performance Al2O3/Y3Al5O12(YAG) eutectic i......
A large undercooling level up to 550K(0.386TE) was achieved in eutectic Ni78.6Si21.4 melt by the combination of molten-g......
Study on the Relationship between Lamellar Spacing and Growth Rate in the Regular Eutectic Growth by
A modified Monte-Carlo(MC) method to simulate the regular growth of binary eutectic alloys is presented. It is found tha......
通过搅拌摩擦加工技术将SiC颗粒加入到A356铝合金中制备铝基复合材料,搅拌摩擦加工参数为:旋转速度1800 r/min和行进速度127 mm/mi......
