论文部分内容阅读
用锥柄插齿刀插削齿轮,锥柄插齿刀的结构尺寸一方面受被插齿轮的结构尺寸和插齿工装的结构尺寸的限制,另一方面受插齿机的主轴行程和锥套孔的限制。设计锥柄插齿刀的结构尺寸时,不但要满足这些限制要求,而且还不可忽视磨齿的结构干涉。图1所示,在磨齿时,同时磨到了锥柄插齿刀的柄部、颈部和工艺柄夹头。这样的干涉,在大平面砂轮磨齿机(如Y7125等)和蜗杆砂轮磨齿机(如苏5832、NZ_2等)上磨削锥柄插齿刀时都可能发生。这
The taper shank shaving cutter inserts the gear. The taper shank shaper cutter size is limited on the one hand by the structure size of the gear to be inserted and the structure size of the gear shaper. On the other hand, it is affected by the spindle stroke of the gear shaper and the taper sleeve Hole restrictions. When designing the structural dimensions of shank taper sharpeners, not only must these limitations be met, but grinding interference should not be neglected. Shown in Figure 1, while grinding, while sharpening shank Shank Shank shank, neck and handle shank. Such interference can occur when sharpening shank shaper shaving cutters on large-face grinding machines (such as the Y7125) and worm grinding machines (eg, Su 5832, NZ_2, etc.). This